Intuitive workflow

Creating a crown has never been easier with the advanced software guiding you through every step. Once the preparation phase has been completed, MyCrown Design takes you through the steps required to take you to the final manufacturing phase.

After the patient has been prepared for scan, the first step to your new design is patient creation in the software and filling in basic patient data.

Various restoration regions require different material selection.
MyCrown can operate with a wide variety of materials including Vita, Ivoclar, Dentsply Sirona, Coltene, Shofu, Merz and GC.

The next step is the acquisition phase using the compact MyCrown Scan camera. To take the digital real-time impression all you need to do is thoroughly scan the prepared area, margin, approximal contacts and 2 neighbouring teeth.

This is followed by scanning the antagonists, especially the occlusal areas.

In order to calculate the proportions of the case, a final scan scan of the buccal bite is required.

Once the scanning has been completed, the software then gives presents you with a virtual 3D model, in colour, of the scanned areas.
Here you set the model axis in the jaw area you are working in.

You are then taken to the model phase. Here you are guided to indicate the margins of the restoration area and define the axis of restoration insertion. Undercuts will be automatically visualised by the software.

The next stage is design. The software uses NatureShape algorithms to offer a fitting proposal with great anatomy respecting the shape of the neighbouring teeth and occlusal contact. Further tools are available for fine-tuning, such as adjustments of the contact points and anatomic shape of the crown

Final adjustments of the contact points and anatomic shape of the restoration can be adjusted.

The software positions your MyCrown restoration in the block, ready to send to the MyCrown Mill. Further adjustments can be made when using TriLux blocks.

The final step is the manufacturing phase. Simply place the block and mill your restoration, thanks to the fully integrated system. In a few minutes you will be holding a beautiful crown or other needed restoration in your hands, ready to be polished and placed in the restoration area.

Your patient will leave with a beautiful smile once again, completed in one visit.